Kitchenaid hot water dispenser manual
Turn the cold water supply line On underneath the sink.
Install a filtration system on the cold water supply line.
The power supply cord is unplugged.The tank should be within 16 inches or less of faucet water lines and manual within 30 inches or less of a standard grounded outlet.For Hot Only Models: If you are installing the filtration system, you'll now insert the outlet tubing into the quick-connect fitting, and then insert the dispenser faucet copper tube - kitchenaid marked with white tape - into the quick-connect fitting.Water Dispenser Not Functioning, if you have no hot water at all from the unit, it may not manual have any electrical power.Slip dispenser the clear 5/16" tube over the far right smooth fitting and slide down approximately 1/2".Builder/dealer name, address, phone number Model number Serial number Purchase date Date installed (See the "Parts and FeatureYsection dispenser for model and serial number label/plate water location.) Keep this book and your sales kitchenaid slip together manual for future reference.Do not extend plumbing or electrical lines.
You can find this information on the model and editor serial number label/plate.
If the problem continues, call an electrician.
Temperature crack Control is not turned to Max.
Vapor near faucet, water is too full hot, boiling water noise Temperature Control setting is too high.Product, registration, card provided with your hot water dispenser.Just as you can set the waters temperature hotter, you can also lower the temperature.The local power has failed.Water has unpleasant taste Hot water dispenser is attached to hot water supply line.Water pressure is too low.The grounded 3 prong outlet editor is operated by a switch.Drill two eighth-inch holes for the wood screws.Also, allow for drainage from the underside if necessary.Provided Tool, important installation safety information is provided in the InSinkErator Instant Hot Water Dispenser Installation, Care and editor Use manual.Water html Has a Funny Taste, any water that sits in the water reservoir may develop an unpleasant taste or editor odor over time.If this happens, you will experience steam and water dripping from the faucet and extended boiling may harm the unit.For example, only the Series 1100 models have the filter as a standard component.For Hot/Cold Models: If you are installing the filtration system, insert the tubing from the outlet side of the filter head into the quick-connect "Y" fitting.
Don't plug the tank unit in yet.
Next, completely insert the 3/8" polyethylene tubing into the inlet kitchenaid hot water dispenser manual side of the filter head.